Jump to content


outboard mechanic near Annap?

phase inhibitor blew

  • Please log in to reply
6 replies to this topic

#1 Clove Hitch

Clove Hitch

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 4,971 posts
  • Location:around and about
  • Interests:Garnacha. Gunk-holing.

Posted 31 October 2012 - 06:42 PM

Anybody know a good outboard mechanic near Napptown? The phase inhibitor blew and I want to get the Manchester gasket replaced while I'm at it. Also, I need a knew recoil spring.

#2 4knotSB

4knotSB

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 1,739 posts
  • Location:75.8760W 39.5142N

Posted 31 October 2012 - 09:47 PM

Look up Solomon Boat Sales, especially if it's Nissan / Tohatsu related.

#3 Clove Hitch

Clove Hitch

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 4,971 posts
  • Location:around and about
  • Interests:Garnacha. Gunk-holing.

Posted 01 November 2012 - 02:54 AM

Look up Solomon Boat Sales, especially if it's Nissan / Tohatsu related.


thanks for the tip, I'll start with them.

#4 Paps

Paps

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 7,024 posts
  • Location:Adelaide Australia

Posted 01 November 2012 - 08:36 AM

Might as well check the flux capacitor while your there.

#5 kent_island_sailor

kent_island_sailor

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 8,443 posts
  • Location:Kent Island!

Posted 01 November 2012 - 11:24 AM

Fairwinds Marina always was good with Johnson/Evinrude engines.

#6 Ajax

Ajax

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 6,704 posts
  • Location:Edgewater, MD
  • Interests:It's Obvious!

Posted 01 November 2012 - 02:29 PM

That damn recoil spring hooks onto a plastic tab in the spring housing. We tried for hours, but can't quite get the right angle to hook the tab when we put the spring back into the housing.

#7 4knotSB

4knotSB

    Anarchist

  • Members
  • PipPipPipPipPipPipPip
  • 1,739 posts
  • Location:75.8760W 39.5142N

Posted 02 November 2012 - 10:50 AM

I just had the same problem with a small lawn mower. Turns out I was trying to wind the spring in the wrong direction . After a new spring and a deep breath to rethink I got it right.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users