Scuff's latest activity

  • S
    Scuff replied to the thread Sagging ceiling.
    I did a cockpit sole from the top and reused the skin. Taper the edges of both pieces and tape them. If the core is rotted you could...
  • S
    Scuff replied to the thread DIY G10 tube.
    Done. I drilled a small pilot on each side measuring from the outside. I ran a piece of tig rod through the hole and checked the...
    • PXL_20220731_223337233.jpg
    • PXL_20220802_211139477.jpg
    • PXL_20220731_223325062.jpg
    • PXL_20220731_225006575.jpg
  • S
    Scuff replied to the thread DIY G10 tube.
    Bowsprit and snubber. Great thanks I'll glue it in tomorrow.
  • S
    Scuff replied to the thread DIY G10 tube.
    It's a 28' horstman trimaran. The wall thickness is 1/4". I hadn't really thought about the size of the dyneema any advice on sizing...
  • S
    Scuff replied to the thread DIY G10 tube.
    Pic of the bow .. the brown line is 6" above dwl. The bow cap hasn't been installed yet.
    • PXL_20220731_150401178.jpg
  • S
    Scuff posted the thread DIY G10 tube in Fix It Anarchy.
    I couldn't bring myself to shell out $200 for a 6" of 1" G10 tube. I made a jig out of 1/2" of mild steel tubing and a split piece of...
    • PXL_20220731_144344914.jpg
    • PXL_20220731_144354957.jpg
  • S
    Scuff replied to the thread Installing G10 backer plates..
    You can use a battery charger to release the fasteners. Use some copper wire attached to the clamps. Touch both wires to a spot on the...
  • S
    Scuff replied to the thread DIY Stainless Railings:.
    I've got a jd2 I've used for roll cage fabrication. What bend radius die did you use?
Show older items
Top