Search results
-
K
no boat speed through water
Hi again guys, finally solved :) when it's done it looks so easy. My Nexus Multi classic display is connected together with Nexus Wind display (that's probably a most frequent setup). The Log, depth and wind connected to NX2 server. The boat speed through the water was not shown because of...- kavaltom
- Post #54
- Forum: Sailing Anarchy
-
K
no boat speed through water
hi, but my log when installed still gives signals to the server when it rotates, faster the engine faster the blinking rate. Was it the same with yours?- kavaltom
- Post #52
- Forum: Sailing Anarchy
-
K
no boat speed through water
I will check 12.7.1 off course. In my setup there is also a miniplex3 shipmodule, can it be used instead GND10? By the way NX2 server does not communicate to windows PC, as Nexus race software needs FDX server, but NX2 does not have FDX. Maybe there an alternative software? An older version...- kavaltom
- Post #48
- Forum: Sailing Anarchy
-
K
no boat speed through water
Then this is the same C13 parameter, when off = stw. This was clear from a very beginning.- kavaltom
- Post #47
- Forum: Sailing Anarchy
-
K
no boat speed through water
Speed towards waypoint? But what if there is no waypoint?- kavaltom
- Post #45
- Forum: Sailing Anarchy
-
K
no boat speed through water
swapping sometimes can damage electronics.. have you seen it swapped and still working?- kavaltom
- Post #34
- Forum: Sailing Anarchy
-
K
no boat speed through water
hi, readings are 0.00 knt, not "---". I wouldn't look for help if I could solve the issue with reading the manuals.- kavaltom
- Post #31
- Forum: Sailing Anarchy
-
K
no boat speed through water
Hi guys, the paddlewheel was not that dirty, few small seashells that stil let the paddlewheel to rotate perfect, anyway all was cleaned thoroughly and put back. Before putting back of course checked if rotations give signal to server- it transmits signals, depending on rotation speed. Server...- kavaltom
- Post #24
- Forum: Sailing Anarchy
-
K
no boat speed through water
so, I did some test again, the boat is at its berth, tiller position in the centre, turned on revers slowly - then led on server starts blinking slow, more speed gives more blinking. Also tried to reconnect the log transducer from/to NX2 server; did check cables nmea in and out; however no...- kavaltom
- Post #17
- Forum: Sailing Anarchy
-
K
no boat speed through water
George, thanks for entering my posts about issue with the boat speed through water. I will check one again which leds are blinking for speed and also if the rate changes at different speeds. bu the way - this is probably a Garmin tranducer GST 43. the boat is fresh purchased I am not absolute...- kavaltom
- Post #15
- Forum: Sailing Anarchy
-
K
no boat speed through water
but the transducer seem to work, as server gets blinking Led, that should mean that paddlewheel is rotating and giving it's signals. So, probably not a cleaning issue. The boat is on water and we sail she time to time.- kavaltom
- Post #9
- Forum: Sailing Anarchy
-
K
no boat speed through water
hi all, I have silvaNexus multi control instrument and nexus NX2 server and speed transducer. Also depth transducer and nexus wind instrument and GPS ploter all connected. Also Miniplex-3 shipmodule somehow is connected. All is ok, except the boat speed. Speed transducer seems to work as NX2...- kavaltom
- Thread
- Replies: 53
- Forum: Sailing Anarchy
